Total Commander Ultima Prime

One For All


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3 Tabstops @ same time (NOT Folder Tabs)
#1
Hello Everybody!

I remembered once I used a Total Commander (UP?) with three Tabstops. It was better than 3 folder tabs, because if you use folder tabs, you always see just two of the folder tabs at the same time.
So I saw the content of three different folder at the same time! I could switch between these with TAB button. It was perfectly when I have to copy the large content of a folder to different folders with the F5 -> F2 function.

Can somebody help me how to enable this option? I searched it but I couldn't find anywhere.

THX for your reply,
Regards,
thebaios
Reply
#2
(06-17-2010, 08:41 AM)thebaios Wrote: Hello Everybody!

I remembered once I used a Total Commander (UP?) with three Tabstops. It was better than 3 folder tabs, because if you use folder tabs, you always see just two of the folder tabs at the same time.
So I saw the content of three different folder at the same time! I could switch between these with TAB button. It was perfectly when I have to copy the large content of a folder to different folders with the F5 -> F2 function.

Can somebody help me how to enable this option? I searched it but I couldn't find anywhere.

THX for your reply,
Regards,
thebaios
You must be wrong. It's a recurring question, TC does not support 3 panels, never did and probably never will. This is because of semantics of TC operations, where one panel is source and the other is target, which are far less clear with 3+.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)